The Popularization Of Electrical Safety Knowledge: Common Sense On The Use Of blade Contact Fuses

1. When selecting L-type Termial, the fuse size should be determined based on the rated current and voltage of the circuit. Choose a fuse that can withstand the current in the circuit and blow quickly if necessary.
2. When installing L-type Termial, install it vertically and follow the correct wiring method. When wiring, pay attention to the order of incoming and outgoing wires, and the tightening of the wiring screws to prevent malfunctions caused by poor contact.

1. Fuse Terminal Contact can usually only be used once. Once the fuse is broken, the fuse cannot work properly and a new fuse must be replaced. In some cases, if the disconnection of the fuse is not caused by overload or short circuit, but due to other faults (such as poor contact, vibration, etc.), you can try to replace the fuse and continue to use it. However, for circuit safety, it is recommended to replace the entire fuse.
2. During use, the status of Fuse End Blade Ferrules should be checked regularly. The inspection includes whether the fuse is intact and whether the contact is good, etc. If abnormal conditions are found, the fuse should be processed or replaced in time.

1. It is prohibited to enlarge or replace the fuse wire of the fuse at will. Doing so may cause the fuse to lose its protective effect, or even cause serious consequences such as circuit failure or fire.
2. When replacing or repairing the blade contact fuse, the power supply must be disconnected first to ensure the safety of the operator. At the same time, appropriate tools should be used to avoid unnecessary damage or electric shock.