How To Check The Fuse in The Car Fuse Box
Sep 25, 2021
Turn off the "eng, NE start stop" switch
The fuse locations are as follows. Check the fuse according to the following instructions. Press the tabs to open the fuse box cover. Under the instrument panel, remove the fuse box cover from the instrument panel on the driver's side. Passenger side instrument panel, remove the instrument panel cover and fuse box cover.
Check whether the fuse is blown. There are:
1 normal fuse
2 blown fuse
Replace the fuse with a properly rated ampere value. The ampere rating can be viewed on the fuse box cover.
If the fuse is blown, replace it with a fuse with an appropriate rated ampere value. The ampere rating can be viewed on the fuse box cover
After replacing the fuse
If the lamp still does not work after replacing the fuse, the bulb may need to be replaced.
If the replaced fuse blows again, ask a Toyota dealer to check the vehicle.
If the circuit is overloaded
The fuse will blow to prevent damage to the entire harness.
matters needing attention
To prevent system failure or vehicle fire
Please observe the following precautions.
Otherwise, it may cause vehicle damage, fire or personal injury.
1 do not use a fuse higher than the rated ampere value, or use any other object to replace the fuse.
2. Pure Toyota fuse or similar products must be used.
Never replace a fuse with a wire, even temporarily.
Otherwise, it may cause serious damage or even fire.
3 do not modify the fuse or fuse box.
Before replacing the fuse
Determine the cause of electrical overload and ask a Toyota dealer for repair as soon as possible.
